Payment & Shipping Terms:
|Maximum Firewall Throughput (Mbps):||150 Mbps||Maximum Connections:||25000|
|Maximum Connections/second:||3000||Maximum 3DES/AES VPN Throughput (Mbps):||100|
|Maximum Site-to-site And Remote Access IPsec VPN User Sessions:||25||Products Status:||In Stock|
|Shipment:||Free Shipping||Warranty:||1 Year Warranty|
IPsec VPN Premium VPN Cisco Security Firewall ASA5505-SEC-BUN-K9
SEC-BUN-K9Security Plus Firewall Edition IPsec VPN, Premium VPN, Active/Standby high availability, 3DES/AES
BUN-K9Firewall Edition IPsec VPN, Premium VPN, 3DES/AES
Market-proven security capabilities
> Extensible integrated services architecture
> Reduced deployment and operations costs
> Comprehensive management interfaces
Table 1 shows the Quick Specs.
|Maximum firewall throughput (Mbps)||150|
|Expansion I/O||Not available|
|Minimum system flash:||64 MB|
|Dimensions (H x W x D)||4.45 x 20.04 x 17.45 cm|
Connecting the Interface Cables
This section describes how to connect the cables to the Ethernet and Console ports.
Warning Only trained and qualified personnel should install, replace, or service this equipment. Statement 49
Caution Read the safety warnings in the Regulatory Compliance and Safety Information for the Cisco ASA 5505 Adaptive Security Appliance and follow proper safety procedures when performing these steps.
To connect cables to the ports perform the following steps:
Step 1 Place the chassis on a flat, stable surface.
Step 2 Before connecting a computer or terminal to the ports, check to determine the baud rate of the serial port. The baud rate must match the default baud rate (9600 baud) of the Console port of the adaptive security appliance. Set up the terminal as follows: 9600 baud (default), 8 data bits, no parity, 1 stop bits, and Flow Control (FC) = Hardware
Step 3 Connect the cables to the ports.
a. Ethernet ports
Step 1 Connect Port 0, the outside Ethernet port, to the public network, that is, the Internet:
Note By default, switch port 0/0 is the outside port. If needed you can change the inside and outside ports assignments later.
Step 2 Connect your network devices with an Ethernet cable to one of the inside ports (numbered 1 through 7).
If you are connecting any PoE devices, connect them to one of the switch ports that support PoE (ports numbered 6 and 7).
Step 3 Check the LINK LED to verify that the network devices have basic connectivity to the Cisco ASA 5505 on one of the inside ports (numbered 0 through 7). When connectivity is established, the LINK LED on the front panel of the Cisco ASA 5505 lights up solid green.
Figure 3-1 Connecting Cables to Network Interfaces
|RJ-45 Ethernet ports||
Step 4 Connect the power cord to the adaptive security appliance and plug the other end to the power source. For information on powering on the chassis, see the “Powering on the Cisco ASA 5505” section
1. 100% Cisco original factory sealed clean serial.
2. Extensive Real Inventory
3. Save up 50%-99% off the Global Price list
4. Flexible payment shipment
5. Unparalleled Experience Service
1. Fast: in 2-3 days upon receipt of payment.
2. Safe: original package with protection foam in case of equipment broken in transportation
3. Economic: Low cost express fee via DHL, Fedex, TNT,EMS,Postal etc.
4. Flexible: We also ship to your Assigned Forwarder or Pickup by your forwarder
Thanks for your visiting! If you are interested in our products or have any question, please contact us online or click " send " the inquiry, we will reply you promptly !